[Ham-Mac] fldigi 3.21.71 posted

[Dick Kriss]

Elwood WB9OEW,

Welcome onboard from a fellow fldigi/iMac user. I listen to incoming (and transmit) audio all the time with the Kenwood TS-590S. I have never used a KX3 and wonder if it mutes the received audio while you are operating digital modes? If so, try a Y-connector to get an audio feed to a speaker. As you can tell I must be missing something with your request.

Dick AA5VU

On May 9, 2013, at 11:41 AM, "Elwood C. Downey" <ecdowney at clearskyinstitute.com> wrote:

> I'm just getting started with digitial and fldigi is already my program of choice on my Mac. I've already
> had some great QSOs using PSK31 and Olivia with my KX3. A big Thank You Dave.
> 
> Just one question: is it possible to have fldigi route a copy of the incoming audio right back to an audio
> output so I can listen to the incoming audio from the rig? I looked at the Mac audio controls and tried
> Soundflower, but these seem only to allow routing audio between apps, not copy from one device to another
> device. So currently I am just using a Y cable to route audio from my rig into both my sound card and my
> headphones, but I suspect this might also feed in a little noise. I've also tried using fldigi to record the
> incoming audio and that works fine also, so it seems like this ability is 99% there already.
> 
> Anyway, great software and thanks again.
> 
> 73, Elwood, WB0OEW
>