[Ham-Mac] Re: Eagle Schematic/ Layout Software

[David Ferrington, M0XDF]

I did download v4, but didn't get around to installing it (a bit of a  
manual task), but now v5 is out and there is a proper Mac Installer  
which makes it a breeze!
I'l have to got read the tutorials now.

Thank you Hans
73 de M0XDF, K3 #174
-- 
The problem with being sure that God is on your side is that you can't
change your mind, because God sure isn't going to change His. -Roger  
Ebert,
film-critic (1942- )

On 8 Apr 2008, at 09:00, ham-mac-request at mailman.qth.net wrote:
> From: Hans-Christian Becker <hcb at fotomol.uu.se>
> Date: 8 April 2008 07:12:40 BST
> To: Mac enthusiasts involved in amateur radio applications <ham-mac at mailman.qth.net 
> >
> Subject: Re: [Ham-Mac] Schematic software
> Reply-To: Mac enthusiasts involved in amateur radio applications <ham-mac at mailman.qth.net 
> >
> On Apr 7, 2008, at 11:32 PM, David Ferrington, M0XDF wrote:
>> a few years ago, I was asking about Schematic software for the Mac.
>> I had replies on Design Works and the other was McCAD (which is  
>> free if run lite)
>> I don't need a lot, in fact I can draw my circuitys on paper, but  
>> thought I'd give a CAD package a go.
>
> A lot of the people on an electronics board I frequent use Eagle:
> http://cadsoftusa.com/
> I have little experience with it myself, though.
> Hans