[Ham-Computers] Re Bleeding percentage?

[WA5CAB at cs.com]

Duane,

I don't know anything about Nero and haven't a clue as to the answer to your 
original question about the label printing problem or I would have responded.  
But if the .079 is inches, no it is not the same as just over 3/4 of an inch. 
 It is approximately 5/64 of an inch.

In a message dated 6/17/2006 10:28:18 PM Central Daylight Time, 
dfischer at usol.com writes: 
> You know I am totally blind, now, but such was not always the case. I do 
> not 
> know what this "bleeding" option means. There is a number in a spin box of 
> .079 Is this the same as just over 3/4 of an inch? If so, this is about the 
> amount of text that is printing to the right of the label boundry. Should 
> this option be left on by default, or should I shut it off?
> 
> Perhaps it has nothing to do with the problem, just wondering. Thank you.

Robert Downs - Houston