[Hallicrafters] SX110 knob removal

[Charlie T, K3ICH]

Well, they may LOOK square, but I think you'll find they are actually 4
flute Bristol spline drives.  If they're square now, someone buggered them.

I guess a thin flat blade screwdriver "may" work, but you'd be much better
off using the proper tool.

73, Charlie k3ICH



-----Original Message-----
From: Hallicrafters [mailto:hallicrafters-bounces at mailman.qth.net] On Behalf
Of Ken
Sent: Monday, June 06, 2016 1:13 PM
To: hallicrafters at mailman.qth.net
Subject: Re: [Hallicrafters] SX110 knob removal

My SX-99's knobs take a square bit.  I used a flat blade screw driver.

On 06/06/2016 09:55 AM, w7ksg wrote:
> How to remove the two small aluminum knobs marked  antenna and standby. I
can't seem to find a wrench to fit the screw holding the knob on the shaft.
> JAC
>
>
>
> Sent from my T-Mobile 4G LTE Device
> ______________________________________________________________
> Hallicrafters mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Hallicrafters at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html

______________________________________________________________
Hallicrafters mailing list
Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Hallicrafters at mailman.qth.net

List Administrator: Duane Fischer, W8DBF
** For Assistance: dfischer at usol.com **


This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html