[Hallicrafters] [AMRadio] sources for alignment tools

[james.liles at comcast.net]

Hi Bob,

I use a 2.5mm allan wrench to start them then the plastic.  Helps to keep 
from splitting the slug.

Kindest regards Jim K9AXN

-----Original Message----- 
From: Robert Sauvan
Sent: Monday, March 30, 2015 6:43 PM
To: Hammarlund Mail List ; Hallicrafters ; AM Radio
Subject: [AMRadio] sources for alignment tools

Hi all,
I am in need of some new alignment tools. In particular, the hex head
piece to tune coil slugs. I have been searching, but only find cheap
looking plastic ones like I have presently. I would like to find
something that is a bit harder and stronger than the ones I am finding.
The ones I have, worked fine for a bit. But, when you run across a tough
slug to turn, they sorta just slip and get rounded off due to the softer
plastic. What is everyone using and where are you getting them?

Thanks-Bob-W0YBS
______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
Archives: http://mailman.qth.net/pipermail/amradio/
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Post: AMRadio at mailman.qth.net
To unsubscribe, send an email to amradio-request at mailman.qth.net with
the word unsubscribe in the message body.

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html