[Hallicrafters] Need Help With SX-101 USB Problem

Thu Jul 16 10:42:46 EDT 2015

Well thought out advice Wayne.  Regards Jim K9AXN

-----Original Message----- 
From: hwhall at compuserve.com
Sent: Thursday, July 16, 2015 12:14 AM
To: ramnaz at peoplepc.com ; hallicrafters at mailman.qth.net
Subject: Re: [Hallicrafters] Need Help With SX-101 USB Problem

I was referring to the USB sideband crystal.

I don't own an SX-101 but just took a look at the schematic on BAMA. The 
sideband crystals are 1600kc & 1700kc. The 1700kc crystal is the one needed 
for USB reception. You could tune those frequencies on an AM band radio and 
verify if the USB crystal is actually running or not when you lose the USB 
function. I was thinking that the crystal may be not starting back up after 
you switch the sideband selection, due to perhaps some component changes 
over time and/or crystal aging.

The V12 12AT7 (Second Conversion Osc.) dual-triode uses one half of the tube 
for the USB crystal oscillator and the other half for the LSB crystal osc. 
In other words the USB and LSB oscillators are two completely separate 
circuits, so one might easily work when the other doesn't. (Rather odd, that 
is, I would have thought they'd just swap crystals and use only one triode 
for the osc.) So, perhaps you should try a couple other 12AT7 tubes. It may 
be that the tube half for the USB is weak.

If that doesn't help, verify that all the components associated with pins 2, 
3, 4 of V12. According to the schematic, those are the half of the tube used 
by the 1700kc crystal. See if any resistor values changed a lot & maybe 
replace the cathode resistor bypass cap at pin 3.

T9 is the coil/transformer for tuning up the USB & LSB oscillators. It may 
be that the USB side needs to be peaked up. The schematic says the lower 
slug in the T9 can is the one that tunes the 1700kc osc. Or perhaps there is 
a fault in the tuned circuit parts in the can if it won't peak up.

This step is for the not-too-weak... swap the two crystals (temporarily) and 
see if the baulky crystal startup moves with the 1700kc crystal or if it 
stays on the same side of the tube circuit. If nothing else helps, this 
would verify that its the fault of an aging crystal.

Hope this makes sense. Perhaps others will have better suggestions for 
testing the oscillator.

Wayne

WB4OGM

-----Original Message-----
From: richard <ramnaz at peoplepc.com>
To: hwhall <hwhall at compuserve.com>
Sent: Wed, Jul 15, 2015 10:23 pm
Subject: Re: [Hallicrafters] Need Help With SX-101 USB Problem

Hello Wayne.
How would I know & are you talking about the Crystal in the tube
in the back left side??
Thanks again for your note.
Richard

-----Original
Message-----
>From: hwhall at compuserve.com
>Sent: Jul 15, 2015 9:19 PM
>To:
mark.k3msb at gmail.com, ramnaz at peoplepc.com
>Cc:
Hallicrafters at mailman.qth.net
>Subject: Re: [Hallicrafters] Need Help With
SX-101 USB Problem
>
>I get the impression the problem might be related to a
crystal that has become sluggish, and needs a lot of excitation to get
started.
>
>
> Wayne
>WB4OGM
>
>
>
>-----Original Message-----
>From:
Mark K3MSB <mark.k3msb at gmail.com>
>To: richard <ramnaz at peoplepc.com>
>Cc: List
Hallicrafters <Hallicrafters at mailman.qth.net>
>Sent: Wed, Jul 15, 2015 5:33
pm
>Subject: Re: [Hallicrafters] Need Help With SX-101 USB Problem
>
>
>Hi
Richard
>
>I have an SX-101A and have exactly the same problem
you're
>experiencing.
>
>I've had my receiver for about 15 years and it
started to do
>this about 5
>years ago.  I swapped the USB crystal with the
one in my SX-111
>and the
>problem went away.
>
>It came back last winter.
USB works fine when
>the radio is turned on,
>but cuts out after a while.
Switching between USB and
>LSB sometimes
>helps;  mostly not.
>
>I recapped
my receiver several years ago
>and also did the cleaning with
>DeOxit.
Obviously, that didn't help.
>
>I
>think the only way to fix the problem is
with an alignment as K9AXN
>mentioned.
>Parts go out of tolerance after 50
years, and I'm not
>surprised part of the
>converter needs tweaked.     I
suspect heating of a
>component and the resultant
>change in value is what is
happening.   What
>you could do it try some freeze
>spray, but the offending
part may be in the
>converter subchassis which would
>make it rather difficult
to get to.
>
>I don't know if you need an entire
>alignment or not;  it's
been many moons
>since I cracked the manual.
>
>73 Mark
>K3MSB
>
>
>
>On
Wed, Jul 15, 2015 at 5:07 PM, richard <ramnaz at peoplepc.com>
>wrote:
>
>>
Hello.
>> Have a SX-101 that  when I go from USB to LSB & then want
>to go
back to
>> USB it is Dead but if I pull the 12AT7 tube out & put it back
>in
then the
>> receive in USB comes back on or if I turn the on & off many
times
>then the
>> USB receive comes back on yet the LSB never goes out.. Any
body have
>this
>> problem & if you fixed it can you tell me how? I have even
put a small
>fan
>> inside & that does nothing .
>> Thanks Much
>>
Richard
>>
>> Richard
>Morris
>>
______________________________________________________________
>>
>Hallicrafters
mailing list
>>
Home:
>http://mailman.qth.net/mailman/listinfo/hallicrafters
>>
Help:
>http://mailman.qth.net/mmfaq.htm
>>
Post:
>mailto:Hallicrafters at mailman.qth.net
>>
>> List Administrator: Duane
Fischer,
>W8DBF
>> ** For Assistance: dfischer at usol.com **
>>
>>
>> This
list hosted
>by: http://www.qsl.net
>> Please help support this email
list:
>http://www.qsl.net/donate.html
>>
>______________________________________________________________
>Hallicrafters
>mailing
list
>Home:
http://mailman.qth.net/mailman/listinfo/hallicrafters
>Help:
>http://mailman.qth.net/mmfaq.htm
>Post:
>mailto:Hallicrafters at mailman.qth.net
>
>List
Administrator: Duane Fischer,
>W8DBF
>** For Assistance: dfischer at usol.com
**
>
>
>This list hosted by:
>http://www.qsl.net
>Please help support this
email list:
>http://www.qsl.net/donate.html
>
>

>______________________________________________________________
>Hallicrafters
mailing list
>Home:
http://mailman.qth.net/mailman/listinfo/hallicrafters
>Help:
http://mailman.qth.net/mmfaq.htm
>Post:
mailto:Hallicrafters at mailman.qth.net
>
>List Administrator: Duane Fischer,
W8DBF
>** For Assistance: dfischer at usol.com **
>
>
>This list hosted by:
http://www.qsl.net
>Please help support this email list:
http://www.qsl.net/donate.html

Richard Morris

______________________________________________________________
Hallicrafters mailing list
Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Hallicrafters at mailman.qth.net

List Administrator: Duane Fischer, W8DBF
** For Assistance: dfischer at usol.com **

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html 