[Hallicrafters] Tuning capacitor grease info

Fri Dec 16 15:05:36 EST 2011

On the money!! I usually clean out and flush the bronze bushings and then use a clock oil with the needle tip to apply. I had some problems with a preselector on one of my Halli's which use a friction setup on the shaft, the bushings were loaded with dried grease and filings. once I cleaned it and relubed it, it worked FB..

-----Original Message-----
From: james.liles at comcast.net
To: hallicrafters <hallicrafters at mailman.qth.net>
Sent: Fri, Dec 16, 2011 8:33 am
Subject: [Hallicrafters] Tuning capacitor grease info

-----Original Message----- 
From: James Liles
Sent: Friday, December 16, 2011 12:27 PM
To: hallicrafters at mailman.qth.net
Subject: Re: Hallicrafters Digest, Vol 95, Issue 13

Hi Bob:

For the bearings in a tuning capacitor, the bronze gears, and bushings in
any of these radios ---- USE ONLY SYNTHETIC CLOCK OIL!  It is refined with
short string molecules and does not dry out or oxidize.  If you use grease
it will drag debris and dust into the gear or bearing whereas clock oil will
drive it out.  You can buy clock and watch oil at most clock shops or go to
your local hobby shop and buy an ounce of the oil that is used to pickle the
two and four stroke engines: it is the same as clock oil.  The only
difference between clock and watch oil is the viscosity.  Clock oil is used
to lub the gear train parts and watch oil can be used to lubricate meter
movements as it is very light.

The use of grease specifically in tuning cap ball bearings comes to no good
end.  It will eventually bind enough to overwhelm the anti backlash gears.

Kindest regards Jim K9AXN

------------------------------

Message: 3
Date: Fri, 16 Dec 2011 07:27:21 -0600
From: "Bob Fay" <rfay at charter.net>
Subject: [Hallicrafters] Tuning capacitor grease info
To: <hallicrafters at mailman.qth.net>, "Hammarlund Radios"
<hammarlund at mailman.qth.net>
Message-ID: <[email protected]>
Content-Type: text/plain; charset="us-ascii"

What type of grease is used to lubricate the shaft bearings on tuning
capacitors? Also what is the best way to clean between the plates of the
tuning cap? The problem I am having is scratchy audio as the radio is tuned.

Bob    WC0D

______________________________________________________________
Hallicrafters mailing list
Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Hallicrafters at mailman.qth.net

List Administrator: Duane Fischer, W8DBF
** For Assistance: dfischer at usol.com ** 

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html