[Hallicrafters] Screws for SX-28s

[WA1KBQ at aol.com]

There's a couple of different sizes on that front panel isn't there? Some  
are #10-28 and others #10-32 I think. The original screws are slotted 
panhead  type 23 thread cutting with a black oxide finish. The correct screws are 
out  there if you know where to look but you might have to buy a minimum 
quantity.  McMaster Carr is a good source for general replacement hardware but 
their normal  stock will not usually have the exact specific type needed for 
correct  restoration work. Recently I found and bought about 600 of the 
slotted  type B black panheads screws National used to assemble their 1930's 
cabinets and  they are an exact match for the originals.
 
Regards, Greg