[Hallicrafters] HA-6 Power Cable

[Carl]

I have a pair of HA-2/HA-6 setups here, both with factory cables. There 
are a pair of 6' cables using #16 on one and the other has 4' cabes with 
#18 and a factory sticker with Part #. The transverters with that one 
are a later production run than the other.

I guess Halli needed to save money!  In any case one of the #18's goes 
to a modified HA-6 which is my primary 6M setup which drives the 
converted NCL-2000 and is used regularly. In such short runs there isnt 
enough current drawn to affect anything.

Use whatever you can find.

Carl
KM1H

----- Original Message ----- 
From: "Glen Zook" <gzook at yahoo.com>
To: "Hallicrafters" <Hallicrafters at mailman.qth.net>; "Robert C. 
Crawford" <k8vfv at arrl.net>
Sent: Friday, January 16, 2009 11:22 AM
Subject: Re: [Hallicrafters] HA-6 Power Cable


> The power cable (original) on my HA-2 (which should be the same as for 
> the HA-6) is NOT shielded and the wires appear to be 16 gauge.
>
> Glen, K9STH
>
> Website:  http://k9sth.com
>
>
> --- On Fri, 1/16/09, Robert C. Crawford <k8vfv at arrl.net> wrote:
>
> From: Robert C. Crawford <k8vfv at arrl.net>
>
> I am new to the list.  I have to make up a new power cable for a HA-6. 
> Can anyone tell me the number and size of the conductors.  Was the 
> cable shielded or un-shielded?  It could be either 9 or 10 depending 
> on how the ground was handled.
>
>
>
> ______________________________________________________________
>