[Hallicrafters] S-38B Finish

[Paul Kraemer]

I use SoftScrub (same thing) on ceramic switches, roller inductors, silver 
plated coils. Miracle worker, just dab it on with a small brush and let sit 
a few minutes, it bubbles, rinse with cold water. Amazing results.
Paul K0UYA
----- Original Message ----- 
From: "ddswl" <ddswl at centurytel.net>
To: "Hallicrafters" <hallicrafters at mailman.qth.net>
Sent: Friday, June 13, 2008 6:01 PM
Subject: Fw: [Hallicrafters] S-38B Finish


> Any bath room cleaner works  great  on  wrinkle finishes that does NOT 
> have lettering. Use a brush, then soap and water & cover with baby oil 
> when dry. Makes it look new!      Regards----Doug
>
>
> Subject: Re: [Hallicrafters] S-38B Finish
>
>
>> Scrubbing Bubbles works wonders even on nasty wrinkle finishes.  They 
>> work HARD..... so you don't HAVE TOOOOooooooooooo........
>>
>> Spray the stuff on but don't leave it too long, maybe 10-15 seconds. 
>> GENTLY wipe it off with a soft cloth.  Repeat 2 or 3 more times as 
>> necessary.  The cloth is going to be very gross, so make sure you use 
>> something you can pitch when this is over.  Again, don't leave it on long 
>> because I'm not sure what it might do to the lettering if left there too 
>> long.  After you have done this, GENTLY wipe it down with plain water, 
>> until the "sticky" feel left by the Scrubbing Bubbles is gone.  Pat it 
>> dry.
>>
>> The results are deamatic.  Amazing!
>>
>> 73
>>
>> Mike
>> WA4DLF
>>
>>
>>
>>> ______________________________________________________________
>>
>>
>>
>> ______________________________________________________________
>>
>>
>
>
> ______________________________________________________________
>