[Hallicrafters] National NC-125 1st IF cathode resistor

[rbethman]

Jim.

In this type of instance, that resistor would have been a value between 
those two points based on final alignment at the factory.  This was a 
typical method of "fine tuning" to get the "desired" results.

You could get a sampling of about 100 of the same model, and find 
results to plot on a curve,, but it won't make YOUR radio any better.

What value is installed?

Bob - N0DGN

James R Carr wrote:
> I know this ain't a hallicrafters subject, but does anyone have a NC-125, that can take a look and tell me the value?
> The schematic just says 330 to 2200 ohms, and i need to know the actual value.
> Thanks
> Jim Carr
> N7FCF
> ______________________________________________________________
>
>   

-- 
Bob - NØDGN