[Hallicrafters] S-108 parts needed

[Jim Tripp]

Oh Yah, I forgot about those little knobs on each side of the SX-110 trim.
Since the 110 has that vertical s-meter on the right hand side of the dial I
assumed that it was a little longer then the s-108.  I guess that means the
glass dial face is not interchangeable either....boo.

Well if anyone has an S-108 you are junking out I would be interested in a
few of the parts. My rig works well, but it could use some tuning up. It
just isn't complete without that trim piece and a good looking dial glass.

Jim/wa6dij

-----Original Message-----
From: Glen Zook [mailto:gzook at yahoo.com] 
Sent: Friday, April 29, 2005 7:26 PM
To: Jim Tripp; Hallicrafters at mailman.qth.net
Subject: Re: [Hallicrafters] S-108 parts needed

The S-108 and the SX-110 use the same cabinet so the
trim piece should be exactly the same length. 
However, the one for the SX-110 has two additional
holes drilled in it for controls whereas the S-108
does not.

I know that the control on the left-hand side is for
the antenna trimmer.  However, I can't remember what
the one on the right-hand side is for.

Glen, K9STH


--- Jim Tripp <wa6dij at redshift.com> wrote:

I need the chrome strip that runs horizontally across
the middle of the front on the S-108 radio.  One from
an SX-110 might actually work, but may need some
trimming because I think it might be just a schosch longer.

Glen, K9STH

Web sites

http://home.comcast.net/~k9sth
http://home.comcast.net/~zcomco

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com