[Hallicrafters] SX-100

[Wayne Light]

Hello All...
 
I'm rebuilding my third SX-100 Mark II and have noticed a consistent error, either in the schematic or at the factory.
 
 
My schematic shows a 300MMf Mica going from pin 2 on V8 to pin 1 of V7.  In each of the receivers I've rebuilt, this cap comes from Pin 3 of V8 to pin 1 of V7.  Has anyone else noticed this?
 
 
Also, probably a dumb question, but why did hallicrafters run two 6.8 ohm resistors in parrallel  to pin 5 of V7? (i.e. why not one resistor of smaller value?).
 
Thanks Guys, I know you have the answers.
 
Wayne K7NCE