[Hallicrafters] SX101 Help

[jack iverson]

HI BILL--  do not remove the four flat head screws on the front panel, 
these are the center two on each side, they hold the front panel to the
 chassis braces. It will be best to replace the four screws with the trim
 washers then turn the rig on its side, you will see 3 holes on the rear 
of the cabinet, there are 3 screws, one in each hole which hold the rear 
of the chassis, now turn the thing (ugh heavy) back on its bottom, remove
the four screws, two on each side, then pull the chassis out.
Be very careful not to bend the pointer,easy to do-been there, done that!
good luck.
Jack                    jackiv at juno.com

On Tue, 3 Feb 2004 20:35:32 -0600 "Bill Campbell" <wd4hen at bellsouth.net>
writes:
> Hi guys,
> 
> I know this should be simple (make that obvious) to remove the 
> chassis from
> the cabinet.  I have removed the eight screws from the front panel 
> and
> expected the chassis to slide out the front.  No way, she will not 
> move even
> the slightest. Now the cabinet was repainted at some point inside 
> and out,
> could it just be stuck to the paint?  This is a nice working rig, it 
> just
> needs some TLC.  Don't want to mess this one up.
> 
> Thanks in advance,
> 
> Bill - WD4HEN
> 
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF **for assistance**
> dfischer at usol.com
> ----
> Hallicrafters Collectors International: http://www.w9wze.org
> ----
> http://mailman.qth.net/mailman/listinfo/hallicrafters
> 
>