[Hallicrafters] Re: SR-150 problem & relay needed

[Al Parker]

Hi Ken et al,
    I just uploaded the right side of the SR-50 skem, overlapped what needs
to be the left side.  Large file, abt 1.6mb, scanned at 200dpi.  Took over 5
min., things are slow this AM.  I aborted the first attempt, just trash the
small file.
    Now that we're on the subject, I need a relay for my SR-150, either K-2
or K-3, they're the same, 3PDT, 800 ohm DC coil.  Operates at about 16vdc.
73,
Al, W8UT
New Bern, NC
BoatAnchors appreciated here
http://www.thecompendium.net/radio/
http://www.hammarlund.info


----- Original Message -----
From: "Kenneth D. Grimm, K4XL" <kgrimm at adelphia.net>
To: "Hallicrafters" <hallicrafters at mailman.qth.net>
Sent: Friday, February 28, 2003 7:03 AM
Subject: Re: [Hallicrafters] SR-150 problem
>
> While I was looking at the schematic for the SR-150, I discovered that
> the right hand edge of the right hand page in the BAMA collection is
> missing.  It would be great if someone could scan that part of the
> schematic and upload it.  I take full blame for sloppy scanning on this
> one.  Gary Harmon went to the trouble and expense of sending the manual
> to me for scanning and then I screwed it up!  And on the schematic, no
> less!!!
>