[Hallicrafters] SX-28 diagrams

[psturdivant n1ps]

Hi Scott,

I have re-capped a couple 28s.  There are no good parts layouts that I am
aware of.  You're just going to have to ID each cap via the schematic and
tube layouts.  The wax caps are easily found anyway.  Make sure you look at
the RF, mixer and IF stage resistors too.    I drew up pictures of each
stage and where each component connects in.  Then I replaced them.  The
components under the RF section are a serious endeavor as the shafts have to
be removed (there was site that that spelled out a step by step approach to
this).

Hope this helps.
ps
----- Original Message -----
From: "Scott Seickel" <polaraligned at earthlink.net>
To: <hallicrafters at mailman.qth.net>
Sent: Thursday, February 06, 2003 6:35 PM
Subject: [Hallicrafters] SX-28 diagrams


> I am looking for a resistor and capacitor placement diagram for the
> SX-28.  I bought the Army manual from the guy on the e-place and
> I am very disappointed in it.  His reproduction is excellent but the
> manual info stinks.  There are no parts placement diagrams which makes
> weeding through the set a pain.  The manual differs on a number of
resistor
> values but only by a small amount.  (eg. set is 500k,  manual says 470k).
> Manual appears to be for later models and probably "A" model.  Most of
> the manual thickness is a comprehensive theory, but if you are in need of
> reading it maybe you should be restoring a simpler set (or none at all!!).
>
>
> Is there a source online where I can download these parts placement
> diagrams?
>
> If not, would anyone be so kind as to e-mail me some scanned images?
>
> Thank You,
> Scott
>
>
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF **for assistance**
> dfischer at usol.com
> ----
> Hallicrafters Collectors International: http://www.w9wze.org
> ----
> http://mailman.qth.net/mailman/listinfo/hallicrafters
>