[Hallicrafters] SX-117

[rdhalste]

----- Original Message -----
From: "Koehl_House" <erkoehl at attbi.com>
To: "DAN COTSIRILOS" <dcsfree at worldnet.att.net>;
<hallicrafters at mailman.qth.net>
Sent: Thursday, October 03, 2002 10:57 PM
Subject: RE: [Hallicrafters] SX-117
Spline wrench. .I've gorgotten, I't been so long since I
owned one.Spl;ine wrench I think...bout 1/16th of an inch.


Roger Halstead (K8RI EN73)
www.rogerhalstead.com
N833R World's oldest Debonair? (S# CD-2)
> Bristol wrench. Two sizes. Most knobs are a 6-flute (size ?)...I have been
> using a hex-wrench, 5/64 across the flats. Be certain the end is flat,
> square, and edges are sharp. Works well. The small knurled knobs, and the
> internal set screws, are a 4-flute (size ?), 5/64-inch across the
flutes...a
> hex won't work for these.
>
> 73, Dick K9FFK
>
>  -----Original Message-----
>  From: hallicrafters-admin at mailman.qth.net
>  [mailto:hallicrafters-admin at mailman.qth.net]On Behalf Of DAN COTSIRILOS
>  Sent: Thursday, October 03, 2002 8:21 PM
>  To: hallicrafters at mailman.qth.net
>  Subject: [Hallicrafters] SX-117
>
>
>  DOES ANYONE OUT THERE KNOW WHAT TOOL IS USED FOR TAKING THE ALUMINUM
KNOBS
>  OFF A SX-117.  DAN
>
>  _______________________________________________
>  List Administrator: Duane Fischer, W8DBF **for assistance**
>  dfischer at usol.com
>  ----
>  Hallicrafters Collectors International: http://www.w9wze.org
>  ----
>  http://mailman.qth.net/mailman/listinfo/hallicrafters
>
>
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF **for assistance**
> dfischer at usol.com
> ----
> Hallicrafters Collectors International: http://www.w9wze.org
> ----
> http://mailman.qth.net/mailman/listinfo/hallicrafters
>