On 07/30/2025 3:56 PM EDT Aidan Riley <[email protected]> wrote:

 

 

Hi all, 

 

I was having issues with the line feed of my Model 33, and was wondering if anyone had a solution or had seen something similar. When I send a line feed character, it sometimes will not fully feed the line, as if the sprocket wasn't pushed down far enough or with enough force. I adjusted the spring to try to fix this but did not have luck. The paper is not slipping at all - the platen is not fully turning. I did also note that the platen turns plenty easily by hand. 

 

73, 

Aidan W9POG

______________________________________________________________
GreenKeys mailing list
Home: http://mailman.qth.net/mailman/listinfo/greenkeys
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

>>> Jordan Spencer Cunningham's GreenKeys Search Tool: https://teletype.net/gksearch
>>> 2002-to-present greenkeys archive: http://mailman.qth.net/pipermail/greenkeys/
>>> 1998-to-2001 greenkeys archive: http://mailman.qth.net/archive/greenkeys/greenkeys.html
>>> Randy Guttery's 2001-to-2009 GreenKeys Search Tool: http://comcents.com/tty/greenkeyssearch.html

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]