Hi everyone! I got the motor loose and am now looking to get some replacement caps. There is a 1MF (uF?) PCB oil cap, guess I get to deal with harazardous waste disposal.

I can not get the wiring block out unless I remove the printer from the base plate. I do not think I need to to do the needful.

Is there a convenient way to apply power to the slip connectors, or will I need to clip into the circuit at the motor?

The pinion is marked 71974, PINION-7T (368-O.P.M.). I can not make out the marking on the matching gear.

Thanks all,

-Eric