Ran some blank plates to make sure mount hole placement was good.   Ran out of 16ga mild steel which is what original was.  Can run aluminum as well.  

Not a problem to run some with the holes if anyone wants some.  

73
John
KG5YLG 

Sent from my iPhone

On Nov 22, 2022, at 1:04 PM, John, W9DDD <[email protected]> wrote:



So which version are you talking about?  Oh, I guess you are talking about a blank panel cut to size unless you know what holes you want. 

If I had found my AL stock, I was going to ask if someone could take a straight on picture of their panel which I was going to then scale for printing to actual size to get a fairly close to the right dimension.