I have model 19 to get rid of. I have no room for it inside.

It is sitting outside with a tarp over it. A local Ham promised

to pick it up yesterday evening - no show.  More than 24 more

hours have passed - still no show.

So it goes to the first person who comes for it.

I have no idea of the condition, other than the printer motor

is governed and all the wires have broken insulation. I would

recommend buying a sync motor from Jim Cooper for it.

I did not look at the TD motor.

I have a feeling it needs some TLC.

I got a 15RO for myself from the same source.

It runs open even with loop current. I figure I will be

working on it for a while.

Located near Point Marion in Southwester Fayette County,

Pennsylvania - about halfway between Uniontown PA and

Morgantown WV. Bring help to load it. I cannot help except to

show you how to break it down into manageable pieces. The

table and and power supply are still monsters.

I want to get rid of it ASAP!

I am sure sitting outside is not helping it.

Tom   N3CRK