[GreenKeys] Mite Connectors

[Tom Hunter]

I have recently come into two working Mite teleprinters. A Mite RO
(AN/UGC-40) and a KSR (AN/UGC-41) The book only gives Mite part numbers for
the mating connectors:

POWER CONNECTOR (Five Pin, MITE Corporation  Part No. 5511-188)

SIGNAL MATING CONNECTOR (Ten Pin, MITE Corporation Part No. 5511-190)

Can anyone give me generic numbers that I might have a chance of locating.

Right now I am using female Molex pins, which work but are crude. And
because of the poor design on the Mites it is necessary to pull them out of
the case for common things like changing the ribbon or the paper (Which
must be done in that order!) and which, for me, means pulling off all those
little pins and later replacing them in the proper places. I would much
rather have the correct connectors and be done with it.

Thanks all for any help.


Tom    N3CRK
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20240414/9d64a0e4/attachment.html>