[GreenKeys] RTTYART Capture Program

[Skip Macaulay]

Hello group, I have been trying to make the RTTYART capture program to work
with my TTY setup. I have sampled off my demodulator output a TTL
signal which is fed onto the UART circuit that feeds the model 28
normally and works.. This TTL signal I fed into a MAX232 chip to
convert back to a RS232
signal and is connected to my serial port on the computer.. I installed the
program and set it up as best as I can figure after reading the documents
but
all I get is garbage on the display.. Groups of letters sometimes and so
on.. I am monitoring the ITTY signal as the source and my question is this:
Should I be seeing what the ITTY signal is being printed on my 28
machine??  The point where I am sampling the TTY signal is the normal 60
WPM signal
before it goes to the UART and is converted up to 100 WPM for my 28 that is
geared for 100 WPM...
Any suggestions will be appreciated.. Skip

-- 
Skip Macaulay
VE6BGT
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20230706/110145b4/attachment.html>