[GreenKeys] Model 14 Keyboard

[B. Smith]

I have never had any luck using the keyboard for loop keying on the 
Model 14, it would key OK with the on board printer magnets but would 
not key properly  with any other equipment on the loop.  I wanted to use 
the keyboard to key my loop for transmitting - - - I think I may revisit 
the project and look at any caps etc in the keyboard filter etc.
k4che

On 8/5/2023 8:16 PM, Eric Moore wrote:
Hello all!

I am working on my 14s keyboard. I have attached a photo and a trace 
from my scope.

It looks like it is bouncing? Any ideas how to improve the signal? This 
is R, so 01010

Thank you for any help! I have my printer kinda working, I am going to 
use the keyboard to dial in the timing on the governed motor.

-Eric