[GreenKeys] Kleinschmidt TT-4C/TG not printing

Steve Garrison steve.n4tty at gmail.com
Tue Oct 4 21:16:50 EDT 2022


Where was the range finder pointing when you got it typing.  If not near the center when typing on a local loop, then there are other issues.

Steve G./N4TTY
Sent from my iPhone

> On Oct 4, 2022, at 9:11 PM, Kevin H. Phillips <kh-phillips at 9-5usa.org> wrote:
> 
> To follow up on this message I posted:  I have finally gotten the machine back to printing from the keyboard.  The problem probably was oil somewhere it shouldn't have been but the fix took some time.
> 
> 
> I tried inserting pieces of paper between the armature and magnets to absorb any oil.  This did not help (at least at first or as far as I could tell).
> 
> 
> I eventually tried spraying Contact Cleaner (WD-40 brand; it dries dry) between the magnets and armature.  This did not help. This evening I started spraying the Contact Cleaner more liberally all over the magnet area as well as on the electrical/electronic components behind the front panel.  This began to help.  I kept typing RY's (one-handed/two-fingered) while adjusting the Range and Armature controls back and forth.  I spent a lot of time doing this.  All I can say is that it finally started working properly. I was typing many lines of RY's as absolutely fast as I could without a single character dropped.
> 
> 
> Another thing I tried was reducing the line current via the rheostat on the front panel.  I turned it down as far as it would go but the meter would not read below 30ma.  I tried slightly increasing it in stages up to about 45ma but the magnets seemed happiest at 30.  I may try a TU with an adjustable loop and see if I can get it lower and see if that helps . . . or hurts.
> 
> 
> It still will not print ITTY.  The loop locks up and I can type on the keyboard but there is no print from ITTY.  I am going to try reducing the audio output and see if that does any good.  It is the only thing I can think to try at the moment.  Maybe the loop current is too high and/or the signal strength is just higher than these magnets can handle (??)
> 
> 
> 73
> 
> Kevin
> 
> W5TTY
> 
> ______________________________________________________________
> GreenKeys mailing list
> Home: http://mailman.qth.net/mailman/listinfo/greenkeys
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:GreenKeys at mailman.qth.net
> 
>>>> Jordan Spencer Cunningham's GreenKeys Search Tool: https://teletype.net/gksearch
>>>> 2002-to-present greenkeys archive: http://mailman.qth.net/pipermail/greenkeys/
>>>> 1998-to-2001 greenkeys archive: http://mailman.qth.net/archive/greenkeys/greenkeys.html
>>>> Randy Guttery's 2001-to-2009 GreenKeys Search Tool: http://comcents.com/tty/greenkeyssearch.html
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to steve.n4tty at gmail.com


More information about the GreenKeys mailing list