[GreenKeys] M28 printer FIGS-LTRS weirdness

[Nick England]

I believe you are correct about bad alignment and hitting the edge of the #
pallet when the hammer is aiming for SPACE. It isn’t a bad # pallet but
FIGS/LTRS not lined up.
Jerry Murphy slowed down the video even more and sent me a diagnosis
earlier today. I just ran his test a minute ago and confirmed bad
alignment. See attached photo. I will perform correction and see what
happens. Stay tuned.
The experience and helpfulness of greenkeyers is really great!
Cheers
Nick K4NYW

On Sun, Mar 13, 2022 at 5:46 PM Jim Cooper <jim.w2jc at gmail.com> wrote:

> On 13 Mar 2022 at 13:17, Nick England wrote:
>
> > It's like the typebox is trying to
> > shift from FIGS to LTRS, but gets
> > stuck where the # pallet is
> > located.......
>
> koool video for demonstrating the typebox action !!
>
> does it only overprint the # after a COLON followed by space  ??
>
> I just noticed ... see the screen clip below ... the shadow
> on the type pallet at the arrow is different from that of
> all the other pallets around it .... is it possible that one is
> a bit off alignment and getting hit by the print hammer
> that is hitting the blank position next to it ?
>
>
>
>
>
-- 
Nick England K4NYW
www.navy-radio.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20220313/ad6b0f09/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image_50337025.JPG
Type: image/heic
Size: 81390 bytes
Desc: not available
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20220313/ad6b0f09/attachment.bin>