[GreenKeys] Model 26 - Looking for diagram on how to setup Paper Roll with Slack Bar

[Duncan Brown]

Charles, Paul,

I am assuming that you do not have the M26 table?  (The table could hold 
the paper roll and slack bar.)

Without the table, the 90942 bracket mounted onto the rear of the 
cabinet.  The slack bar hangs down (supported by the Slack Bar Lines) 
from the bracket.  The paper goes from the roll, down under the slack 
bar, and then up into the slot in the rear of the cabinet.  Thus, the 
slack bar keeps tension on the paper.

Hopes this helps.

Have fun,

Duncan
K2OEQ

On 06-Jul-22 07:53, Charles Baetsen wrote:
> I recently picked up a Teletype Model 26 and I cannot find any 
> diagrams on how to set up the paper roll hanger and slack bar. The 
> paper roll bracket was easy enough to figure out, but I am not so sure 
> about the slack bar.
>
> The parts I have are (according to the parts manual):
>
> 90942 Paper Roll Bracket
> 90796 Paper Spindle
> 3181 Slack Bar
> 3841 Slack Bar lines
> Shown on page 12 of  Parts Manual for the Model 26 (1074B-Iss2-Jan45)
>
> I could not find a diagram anywhere of how to set this up. If someone 
> could provide a diagram or a photo that would be great.
>
> Charles...
>
> ______________________________________________________________
> GreenKeys mailing list
> Home: http://mailman.qth.net/mailman/listinfo/greenkeys
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:GreenKeys at mailman.qth.net
>
>>>> Jordan Spencer Cunningham's GreenKeys Search Tool: https://teletype.net/gksearch
>>>> 2002-to-present greenkeys archive: http://mailman.qth.net/pipermail/greenkeys/
>>>> 1998-to-2001 greenkeys archive: http://mailman.qth.net/archive/greenkeys/greenkeys.html
>>>> Randy Guttery's 2001-to-2009 GreenKeys Search Tool: http://comcents.com/tty/greenkeyssearch.html
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to duncanancy at earthlink.net