[GreenKeys] M28ASR Motor Saga

[Jim Haynes]

I have replaced a lot of noisy motor bearings, but it's been a while so
I don't remember the exact procedure.  But I know I didn't have the
official bearing puller.  Maybe something I got at an auto store.  Since
the bearings you are taking off are no good it doesn't matter if you
ruin them further getting them off.  And to put the new ones on you just
need a piece of pipe or tubing that will fit over the shaft and press on
the inner bearing cylinder.  And then start the bearing onto the shaft
and tap on the end of the pipe.

 	---

 	"Ya can argue all ya wanna, but it's dif'rent than it was."
 	"No it ain't! No it ain't!  But ya gotta know the territory."
 		Meredith Willson, The Music Man