[GreenKeys] 26A Table

[til128 at juno.com]

Hi all:

Hope this finds you well and safe.

I recently acquired a Model 26 KSR and 26 table with the paper handling equipment inside that I am refurbishing.

I have looked high and low for information about the table itself but have found none.

Except for some paper handling info and electrical parts placement, I have found no info about some questions I have about it.

??  What are the parts that keeps the cover from sliding around on the table? There are 3 holes in the table that line up with the cover.

?? What holds the 1/4 inch finished cover to the table besides the 6 flat head screws on the edge. There are 2 holes in the front center that also line up with holes in the table.

??  Was there a pilot light in conjunction with the on/off switch. There is a 5/8" hole that I assume there was one just above the switch.

??  What type of feet were used on these. I think it used the same ones the the 15, 19 Etc. used..but there are nail (brad) holes where the feet should go. Anyone know for sure?

The table is marked 26A

Any help with part numbers, pictures or directions to info would be greatly appreciated.

Please reply off list unless it is of general interest.

Thanks in advance,

Tom WB2TTY




____________________________________________________________
Sponsored by https://www.newser.com/?utm_source=part&utm_medium=uol&utm_campaign=rss_taglines_more

Nations Praised for Their Virus Policies Run Into Problems
http://thirdpartyoffers.juno.com/TGL3131/5eb6f7cb699ba77cb4cd0st02duc1
America's 'Virus Hero' Is Suddenly Taking Heat
http://thirdpartyoffers.juno.com/TGL3131/5eb6f7cb8c2a677cb4cd0st02duc2
The Coronavirus Gets Closer to Trump
http://thirdpartyoffers.juno.com/TGL3131/5eb6f7cbaedf677cb4cd0st02duc3