[GreenKeys] model 28 KSR

[til128 at juno.com]

Hi Virgil:

Take your meter and start at 5 on the C terminal. That should go to the selector magnets and come out at 6. Jumper to 7 and then to the key board and then out on 8. Jumper to 9 to the motor stop control (if there is one) and then out to the line at 10. So - the signal line is 5 and ten.

Tom

Please note: message attached

From: Virgil Bierschwale <vbiersch at gmail.com>
To: GreenKeys <greenkeys at mailman.qth.net>
Subject: [GreenKeys] model 28 KSR
Date: Sun, 7 Jun 2020 14:40:03 -0500


____________________________________________________________
Sponsored by https://www.newser.com/?utm_source=part&utm_medium=uol&utm_campaign=rss_taglines_more

Powell: Trump Has 'Drifted'
http://thirdpartyoffers.juno.com/TGL3131/5edd5dd0c34eb5dd065bdst01duc1
Eccentric's Treasure Chest Is Finally Found
http://thirdpartyoffers.juno.com/TGL3131/5edd5dd0de02a5dd065bdst01duc2
$2M Candy Order Turns Bitter for Top Official
http://thirdpartyoffers.juno.com/TGL3131/5edd5dd151085dd065bdst01duc3
-------------- next part --------------
I've been studying the schematics for this model 28 I received last year
and if I understand them correctly, it looks like I want to hook up the
loop supply to pin's 21 and 22.
Looking at the wire colors, they are in fact a red wire and a black wire
and nothing is hooked to them.

I have attached a picture of it.

can anybody verify that as I don't want to screw anything up.

Thanks,

Virgil
N5IVV
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20200607/1231270e/attachment.html>