[GreenKeys] ASR 33 problems

[tomas at tlec.se]

Ok, the AB drum does not rotate when I press “Here Is”, although the catch probably tries to do it, might be seized.

Regarding the LF-rubber, how do I determine its size, should it touch the metal lever or should there be any distance?

Just realized that I have numerous of 4-40 studs (DB-Connectors use UNC4-40), just need to break of the external thread.

Here in Sweden Imperial threads are unobtanium, unless you want a couple of thousands.

 

Mvh

Tomas Larsson

Sweden

 

Från: WAYNE <teletypeparts at comcast.net> 
Skickat: den 18 april 2020 20:08
Till: tomas at tlec.se; GreenKeys at mailman.qth.net
Ämne: Re: [GreenKeys] ASR 33 problems

 

Tomas, 

 

The AB drum rotates when you press the Here Is key or when you are connected to another machine and they press CTRL E (WRU) (who are you?).  Not used much on a computer model.  

 

With the orange plastic broken off, the LF will not work.  See the factory one and some fixes attached. 

 

Dont know about the CR.  Perhaps a function bar out of place.  First make sure you are generating a CR by looking at the codebars that extend out of the printer to the left.  CR is  1348 counting from the rear.  They will extend out to the left while the other codebars stay to the right when you depress CR key. 

 

The nut is 4-40 Hex if you can find one at a hardware store.  Be sure and use a lock and flat washer.  Hold the wheel with your fingers when you do the final titening.  Just snug it lightly when adjusting positioning.   

 

If you cant find a nut I can send you one and the sub in the last pic which just pushes on your existing LF upstop with a nut driver or the like. 

 

Just pay the shipping.  I need your full address.  Might take a while to get there. 

 

Wayne 

KB1FDW 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20200418/f22c1148/attachment.html>