[GreenKeys] Woot! M15 has arrived - and I am already STUCK!

[John Nagle]

> On Sat, Sep 5, 2015 at 6:45 PM, drlegendre .<drlegendre at gmail.com>  wrote:
> The unit showed up today, and it seems to be in truly excellent shape. No obvious damage or signs of extensive wear or abuse. It has lost a fair bit of black wrinkle paint off the typing unit frame, but I can't complain about that.
> But despite all of the other preparations I made for it, building hardware, writing software, etc.. I can't figure out how to hook the dang thing up!
> I have quite a few pieces of documentation for it, perhaps too many - but so far, I can't find a simple?
> "Here is how to connect the M15 TTY" section.?
>
> Underneath the cover, the machine has two double-row screw terminal blocks. A long one on the RH side about mid-way along, and a shorter one on the LH side, near the rear.?
> There is an AC power cord connected to two of the RH terminals. There is also a male TRS plug connected to two terminals on the same block. Only the T and R connections are used, the sleeve is unwired.
> So.. where are the Tx- / Tx+ and Rx- / Rx+ connections, where I can hook-up my RS-232 / 60mA converter? Any other assist would be welcome, as there's also this question about a line relay (that allows a remote machine to enable the printer, I think).?
> As ever, TIA..
> -Bill

See
"www.aetherltd.com/refurbishing15.html". Scroll down to  "Wiring",
to the table which says "The usual external connections are". Note
the simple tests under "Notes" to make sure your machine has
standard wiring.

All three Model 15 manuals (Description, Adjustments, and Parts) are
here, as PDF files:

http://www.aetherltd.com/manuals.html

			John Nagle