[GreenKeys] TT-100G Selector Assembly

[The Rices]

Question for those that might know more about these then me. (Not hard)

I found the reason the keyboard was not accurate in sending to the typing 
unit was a couple of reasons but one was the fact that the screws,nuts etc. 
were loose on the Selector magnet assembly. I have removed the assembly and 
see that someone had started to make adjustments and stopped.

Now it is my turn and I have a question. When I reset the selector magnet to 
the proper clearance before any other adjustments should I be able to move 
the armature to mark or space and it stay there until I move it to the 
opposite ? Before it was loading back to the space side when it was idle. I 
wanted to be sure before proceeding to the next step.

One other question, the manual says armature adjustment is parallel within 
.002 inch but parallel to what?

Oh, it has a 1 3/4 magnet and I have set it at .004 from the armature if 
that helps and have the armature adjustment screw backed out at the present 
time.

Any help would be appreciated.
Thanks
Steve
N4YZA