[GreenKeys] Model 28 etiquette

[Randy and Sherry Guttery]

Larry Tighe wrote:
> What is the correct "factory" procedure for restoring a Model 28 RO...as follows.....
>
> I've restored the cabinet, new RO base and a sprocket feed printer.  If there is no ESU, where/how do you control the AC to the motor?  Must there be an ESU, always?
>   
Depends on which cabinet...  but the short answer is no - (but, which 
cabinet is it?)
> The cable connection to the magnet will go to the terminal board's correct connections.  Is connection the loop directly to the TB "factory" approved?
>   
Again - depends on cabinet - and a couple other things...

The compact (not skin tight) doesn't use an ESU - rather terminal block 
across the rear. The "standard" cabinets (both table and floor) usually 
use an ESU - but not always. I've never had / worked on a skin tight - 
so would defer to those with that knowledge / experience.

let us know...  

-- 
randy guttery 

A Tender Tale - a page dedicated to those Ships and Crews
so vital to the United States Silent Service: 
http://tendertale.com