[GreenKeys] (no subject)

[Ralph Mowery]

----- Original Message ----- 
From: <wb0cte at netscape.net>
To: <greenkeys at mailman.qth.net>
Sent: Monday, December 20, 2010 10:19 AM
Subject: [GreenKeys] (no subject)


> Anyone know how to get MMTTY to run at 100wpm?
> ?
> Wayne? wb0cte
>

YOu set the baud rate to 75 for 100 wpm teletype.

Go to OPTION,  SETUP, DECODE..  Then whree the Baud Rate is, change the 
45.45 that should be there for 60 wpm to 75.  The other parts should be the 
same as 60 wpm.

For the one that asked what MMTTY is, it is a sound card program that you 
feed audio into the computer and it prints out teletype to the computer, you 
can also send out the audio tones to transmitt with or just to the speakers 
so you can hear them. The program works very well and is free.  You can get 
it here:

http://www.muenster.de/~welp/sb.htm

YOu will see a lot of programs and this one is about 1/4 way down the page.

Someone mentioned the ham speed limit.  In the US it atleast up to 100 wpm 
Baudot on frequencies below 30 MHz.  I don't know about the other parts of 
the world.