[GreenKeys] ASR-33 parts available

[Roy Morgan]

Greenkeyers,

I have the following parts available for the ASR-33, which machine I am not 
likely to ever own.

I don't know values, but am open to offers or trades:  I have Model 14/15 
equipment and model 28 KSR's, would use paper, tape, patch cords (T-R or 
T-R-S).

I'm especially looking for any TMC terminal unit of any sort, working or 
restorable.


Here are the parts:

Motor, part No. 181870
- includes fan, shaft pinion, driven gear with belt drive gear, 
bracket/shaft upon which the driven gear runs, and two semi-circular hold 
down clamps.  Appears good. Four wires, blue red, yellow, and green ground.

Two nylon gears, driven and toothed belt marked 181420, one is split
One same wheel new in package 181420

Two toothed belts, about 10" overall circumference, fit above gears

Black bracket
- with solenoid coil (marked "300M"), leaf switch with cover marked 
"Caution High Voltage" - appears unused, wires with 15-position Molex male 
connector (2 female, four male pins present), and 4 push-on connectors

Two ribbon wires with four plastic 16- pin connectors:
- 3 female connectors marked 206037-1, one male marked 206036-3
(Doesn't *look* like Teletype, but these were in the box.)

One nylon platen hand wheel.

One circuit board, about 2-1/21 x 4-1/4  has 5 power resistors, board was 
overheated but is fixable, 15 pin edge connector stripes, key slot between 
8,9. board etched 181823 and silk screened 0.29A - .060A NEU 181821

Two type wheels 180598 new in packages Dated 1978

One push button panel, light brown, clear push shafts  REL., B.S.P., OFF, 
ON, appears complete and undamaged.

One black shaft on mounting brackets, rubber bushings.  Has 4-5 levers with 
contact surfaces, one roller, held in position with a little green steel clip

One motor starting cap, blue, slip-on terminals on wires, 88-108 MFD (untested)

One fuse holder bracket marked 2-1/2A SL-BL

One brown cylinder thingy with teeth, 1-1/2" long, 7/8" diam. has short 
"shaft" on each end. One tooth broken out.

One over current cutout (?) three slip-on terminals, black rectangle 1" by 
7/8' by 1-3/4", with metal mounting ears having one keyhole shaped hole

One circular bronze bushing ID 1/4" OD 3/4" length 3/8"

One relay armature plate (?), has black adjustable plate

A few other small bits and pieces:
- 6" bar with notches
- small rubber bumper
- half tiny rubber foot
- three small black stamped parts
- a couple of tiny springs about 7/16 long overall.
- a few 8-32 or 6-32 hex head screws.

Roy



- Roy Morgan, K1LKY since 1959 - Keep 'em Glowing!
7130 Panorama Drive, Derwood MD 20855
Home: 301-330-8828 Cell 301-928-7794
Work: Voice: 301-975-3254,  Fax: 301-948-6213
roy.morgan at nist.gov --