[GreenKeys] 32/33 Rubber Hammers

[gil smith]

What about turning some on a lathe?  Chuck a hard-rubber or soft-plastic 
bit of stock, turn the OD, a flat face, and hollow the face down to the 
needed depth (for the snap-on side).  Then make a little tool to cut the 
groove on the inside.  Then just part it off (at the hammer-side) to the 
proper thickness. Maybe?

gil


At 08:09 AM 7/29/2005, you wrote:

>It looks like I may have found a source of a few old but usable model
>32/33 print hammer "rubbers". Now I ask again, is there any one who
>knows a way, a source, etc, of making new "rubbers" in silicone or any
>other material?
>
>     Les  K1YCM/3
>
>_______________________________________________
>GreenKeys mailing list
>GreenKeys at mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/greenkeys



Vaux Electronics, Inc.
480-354-5556
(fax: 480-354-5558)
www.vauxelectronics.com