[GreenKeys] Unshift on Space

[dave sigafoose]

Russ,

Thanks so very much for the information.  This list is
amazing.  

I did exactly as you recommended.  Found the set screw
in front of position 1, and after 1 1/2 turns counter
clockwise, my M28 is now 'unshifting' on space.

Thanks again for the help....

Best Regards,


Dave Sigafoose - N2CZB

NNNN

--- Russmill47 at aol.com wrote:

>  
> In a message dated 12/27/2004 11:20:06 A.M. Eastern
> Standard Time,  
> davesigafoos at yahoo.com writes:
> 
> Does the  model 28 also have the same ability and if
> so, how does one make the  adjustment.
> 
> 
> 
> Dave,
>  
> The M28 handles unshift-on-space within the stunt
> box. 
>  
> When a space is typed, it will pull a shift fork on
> the top part of the  
> stunt box which, in turn, operates the bottom code
> bar and puts the M28 into  
> lower case if it were in upper case.
>  
> About the middle of the top part of the stunt box at
> slot one is a bolt and  
> locking nut.  If this bolt is run down into the top
> of the stunt box, it  
> causes the front of the function pawl in slot one to
> tilt down, casing the rear  
> part to raise. 
>  
> Front in this case is the business end of the stunt
> box which faces into  the 
> guts of the M28. The rear is toward the stripper
> blade. 
>  
> If the function pawl is raised, it disables the
> downshift on space  feature.
>  
> If your M28 is not unshifting on a space character,
> the bolt should be  
> backed out to a point when this function is enabled.
>  
> 73,
>  
> Russ
> WA3FRP
>  
>  
> 



		
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - Find what you need with new enhanced search.
http://info.mail.yahoo.com/mail_250