[GreenKeys] Fellow ham seeks help

[Bob Camp]

Hi

This is a basic problem with any setup using the Kantronics or similar 
boxes. There is no dedicated mark / space output to drive a scope. 
Older TU's like the ST-6 had this feature.  The KAM XL does not have 
this feature.

When I asked the Kantronics guys what they did about this at the Dayton 
Hamfest 10 years ago their answer was: "We use a sound card program on 
a PC to tune with" . I did not think that was a good answer then and do 
not think it's a good answer today. However it is what most people do.

	Take Care!

		Bob Camp
		KB8TQ


On Aug 9, 2004, at 11:40 AM, Web Williams wrote:

> The following request for help was just posted on eHam.net. If anyone
> can send me an answer for this fellow, I'll post it on eHam for him.
>
> 73, -Web Williams in Myrtle Beach, SC
>
> Hello and thanks to read this post.
>
> I'm having some problems to monitor
> the RTTY Wave/signal on my Station Monitor SM-220
> with the Kenwood TS-950SDX and a Kantronics TNC
> (Kam XL).
>
> I've connected the rear cinch and the front V.INPUT
> and with those connections I can monitor the band frequency and my 
> output transmission (SSB/CW), but:
>
> How I can check the RTTY output signal (wave) ?
> Where to take the Mark/Space on the Kantronics or
> even on the TS-950SDX ?
>
> Many thanks for any tip.
>
> My best 73
> de HB9DHG Fulvio
> http://www.hb9dhg.ch
>
>
> _______________________________________________
> GreenKeys mailing list
> GreenKeys at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/greenkeys
>