[GPS_Standard] Montrol Question

[Stanley Reynolds]

Hit the read back again, same button.


----- Original Message ----
From: "k7hbg at dslextreme.com" <k7hbg at dslextreme.com>
To: Stanley Reynolds <stanley_reynolds at yahoo.com>
Sent: Friday, May 16, 2008 9:53:07 PM
Subject: Re: [GPS_Standard] Montrol Question

Thanks Stanley;
Ok, Ive clicked the [control] button and the "Standard Control panel" is
visible. I clicked the [Parameter Read Back] button and the controller
settings are visible. I want to change "Holdover Limit] and after setting
the value to 21 in the little window, what should I do now to set this
value in the controller?
Bob



Stanley Reynolds
> From the tool bar select Control button in GPS standard section.
> This starts a new window with the settings, first read the current
> settings then you can change them.
>
> Stanley
>
> ----- Original Message ----
> From: "k7hbg at dslextreme.com" <k7hbg at dslextreme.com>
> To: gps_standard at mailman.qth.net
> Sent: Friday, May 16, 2008 9:19:11 PM
> Subject: [GPS_Standard] Montrol Question
>
> Hi everybody;
> I'm sure this is right in front of my knoze but, here goes.
> Everything is working just fine and now it is time to "tune" (fiddle)
> with the control settings. I'm looking at the "GPS Standard Control"
> panel. I'm pretty sure that I can transfer settings to my controller from
> this panel but, how? Is there some documentation on the proper operation
> of the MonTrol Control panel?
> Regards, Bob K7hbg
>
>
>
>
> ______________________________________________________________
> GPS_Standard mailing list
> Home: http://mailman.qth.net/mailman/listinfo/gps_standard
> Help: http://mailman.qth.net/mmmain.htm
> Post: mailto:GPS_Standard at mailman.qth.net
>
>
>
>
>