[FoxHunt] 440 MHz HT and other items FS

[Ken Simpson, W8EK]

Kenwood TH-41 BT HT for 440 MHz For Sale:

The Kenwood TH-41 BT is an easy-to-use and compact 440
MHz HT. Frequency selection is via thumbwheel switches
on the top of the radio. There is a DTMF touch tone pad
on the front, along with DIP switches for selection of
the built in PL subaudible tone.

This HT is a "Tech Special" or could be used for parts.
It could also be used to get subaudible PL tone if you
have one of the older "AT" models that lack the tones.
Basically, this unit transmits fine. On receive it sounds
like it is working (squlech action is OK, it has audio,
etc.) but a signal is not received. It acts like the
receiver may be off frequency. Of course it could also
be used for "fox hunts" since the transmitter works fine.

I am selling the HT only, with no accessories.
Cosmetically it is nice. I will include both operating
and service manuals on CD. $25


Accessories for the Kenwood TH-21 / 31 / 41 series HTs:

Special Antenna adapter that fits the TH-21 series HTs,
and has a BNC on the other end. $10

Kenwood SC-8 T "Soft Case" for any of the TH-21 series HTs
great condition $12

Original Operating manual for TH-21 HT for 2 meters $8

MFJ 287 Speaker Microphone
This was used on a Kenwood TH-225 HT, but it also fits the
TH-21/31/41 series HTs, TH-205, TH-215, TH-415, as well as
others. It has a 3 conductor 3.5 mm plug and a 2 conductor
2.5 mm plug. It works fine. $15

Kenwood W09-0315 charger
This charger is used to charge the larger PB-21 H batteries
for the TH-21 series, and also on other Kenwood radios.
It has a standard 2.1 mm coaxial connector. $12


Rubber Duck antennas for your HT For Sale:

All are for 2 meters, are in good condition,
and are $10 each, unless stated otherwise.

BNC - Original from Kenwood TH-215, about 5 inches long

BNC - Stubby about 4.5 inches long

5/16 inch threaded, as used by Motorola and others
Stubby - 4 inches long

Type F connector - 6.5 inches long

PL-259 connector - 6.5 inches long
HyGain 275, still in original packaging

PL-259 connector - Stubby - 4.6 inches long
Centurion, still in original package

BNC Stubby for 440 MHz, 3 inches long


Coax connectors and adapters:

Prices are per connector. Several of each are available.
Most are unused.

UHF Right angle 90 degree elbow connector $3

UHF double female "Barrel connector" (two SO-239 together) $3

UHF "Bulkhead Connector" - Double female, as above, but for
mounting thru a window, siding, etc. about 3 inches long $6
-
UHF double male connector (two PL-259's together) $3

UHF "T" connector with two female (SO-239) and one male
(PL-259) connection $5

Antenna adapter to fit the BNC connector on the HT
and provide an SO-239 connector that will permit
a PL-259 to be attached. (BNC male to UHF female) $5

UHF Male to BNC female (opposite of above) $5

BNC male for coax cables
standard type $2
crimp on type $3

Chassis mount BNC female
square mount (uses 4 screws) $3
screw in type $3

BNC "T", two female and one male $3

"N" Connector, Double Male $8


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs,
HF and VHF/UHF antennas, etc.
Just too many to list here. Please e-mail your requests.

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400