[Fox_Tango] HF Rig, Speaker, Mics, HT Accessories and more FS

[Ken Simpson, W8EK]

Yaesu Items For Sale  --  Filtered speaker, HF transceiver,
microphones, cables, linear amp switch box, HT accessories,
and more


Yaesu SP-6 Speaker with phone patch and Filters:

This Yaesu SP-6 speaker has the phone patch and filters in it.
It is the matching speaker for the Yaesu FT-990 and many others.
It permits one to switch between two different rigs, and has
adjustable filters on both the high and low end to permit one
to get rid of QRM, and have a great sound.

This one is in extremely nice condition and works 100%. Not
a single scratch or mark on it. You will not find a nicer one
unless it just came out of the box.

With paper work for $150.


Heath SB1400 HF Transceiver (similar to Yaesu FT-747):

This is a 100 watt multimode HF transceiver covering 160 to
10 meters (including WARC bands). It operates on SSB, CW,and
AM. The receiver is very sensitive. This rig has noise blanker,
squelch, adjustable AGC and attenuator, as well as memories
and two VFOs. A narrow CW filter is included. It even has a
computer interface and is very similar to the Yaesu FT-747.

This one works 100% and looks very, very nice.
It includes power cord and paper work for $300.


Yaesu MH-1 Hand Microphone:

The Yaesu MH-1 b8 is the hand mic that is used on most of
the Yaesu HF and some of the Yaesu VHF rigs. It is a hand
mic that has a switch on the back with two audio frequency
responses -- one for rag chewing, and one for more punch
for DX. It has up and down switches, in addition to a
"fast" switch. Of course it also has the normal PTT
switch. It has a round 8 pin mic connector, wired for
Yaesu.

This particular microphone looks like it might not have
ever been used. I think it was probably put in a drawer
when new, and left there. Of course it works fine. $38


Heil HM-10 Deluxe Microphone:

The Heil HM-10-5 is a beautiful microphone resembling the
"gold line series". It has the HM-5 wide element for good
frequency response, and good articulation.
This particular microphone looks very close to new.
It includes paper work in its original fancy Heil box. $75

Cables for Heil (and other) Microphones:

Heil CC-1 Y  cable for Yaesu (yellow)
Connects to Heil mics with the 4 pin XLR connector (most
Heil mics), and has a round 8 pin connector wired for Yaesu,
plus a jack for PTT. $25

Hand held PTT switch
The Heil Microphones require a separate PTT switch -- either a
hand switch or a foot switch.  This is a home made hand switch.
It is similar to the Heil, except it is in a 1 x 1 x 2 inch
minibox, with about a 3 foot cord.  It works and looks fine.
$12

Heil CC-1 XLR 4
4 pin XLR Female to 3 pin XLR Male $25

3 pin XLR to stripped ends
About 10 feet of quality rubber covered mic cable with a 3 pin
XLR connector on one end. Ideal to add your own connector.
Can be used with the CC-1 XLR-4 above. $20

Heil Wind Screen
This windscreen can be used with a variety of microphones,
including the HM-10. Excellent condition. $8


Yaesu FRB-757 relay box to switch linear amplifier:

Many of the more modern rigs are not capable of switching
the larger currents and higher voltages of the transmit
receive relays of some linear amplifiers. This small box
was made by Yaesu to remedy that situation. Although it
was made for the FT-757, it can be used with almost any
rig that needs a "beefier" relay to switch the linear amp.
It does not even need to be a Yaesu rig. This box needs
13 V DC (and has an RCA phono plug for that purpose), and
is connected to the rigs linear amplifier relay output
with another RCA phono plug. The output of the box has
both normally open and normally closed contacts, both
terminated in RCA phono jacks. Contacts are rated at
600 VA AC, 150 W DC load, and will switch up to 250
volts and up to 5 amps.

This unit may not have ever have been used. It tests fine.
Paper work is included for $40.


Yaesu CT-20 Adapter Cable:

The CT-20 adapter cable is made to be used with the Yaesu
MD-1 desk microphone. As the MD-1 c 8 comes from Yaesu,
it has a round 8 pin connector on it to plug into the rig.
The CT-20 cable is used in place of the regular cable, to
adapt to one of the Yaesu rigs that takes the newer 8 pin
modular (like a computer LAN) connector. The CT-20 has a
round 8 pin connector on one end that goes into the desk
mic, and a modular connector on the other end for the rig.

This particular cable is still sealed in its original
package, unused, unopened. $20


Yaesu HT Accessory Items:

Yaesu E-DC-5 B Cigarette Lighter Cord
DC Cable with voltage regulation, filtering and cigarette
lighter plug. For many Yaesu handheld radios including
FT-530/415/50R/FT-60R, VX-5/VX6/VX-7/VX-8/VX-170, etc.
These sell new for $27.  Buy this one for only $18.

Battery pack for Yaesu VX-2 or VX-3 HT
Lithium Ion Battery Pack fits both the VX-2 and the
VX-3. 3.7 volts, 1200 mahr, works great, and holds a charge
like new. $15

Yaesu NC-18 B Charger
Provides 14.5 V DC at 50 ma to charge many different HTs,
including the Yaesu FT-411, FT-811, FT-911, FT-23, FT-209,
FT-415, FT-410, FT-470, FT-727, FT-530, FT-703, and more.
Small 2.5 mm male plug. $10

Belt Clip for Yaesu FT-207, with hardware. $8

Wrist Strap for Yaesu FT-209, and probably others $4


Prices do not include shipping from Florida.


I also have many other accessories available such as many
different types of HTs, VHF and UHF rigs, HF and VHF/UHF
antennas, etc.
Just too many to list here. Please e-mail your requests.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone  (352) 732-8400