[Fox_Tango] FT-101E Low output on 20 only

[R_Davis]

Sounds like a neutralization problem. Check (and adjust if necessary) for
nearly symetrical dip in the plate current.

Rick, WD8JJA

----- Original Message -----
From: "W Sanders" <wsanders@wsanders.net>
To: <fox_tango@mailman.qth.net>
Sent: Sunday, August 04, 2002 7:57 PM
Subject: [Fox_Tango] FT-101E Low output on 20 only


> I have this strange thing happening on 20 only on my FT-101E - I have
generally low output on 20, 15, and 10, about 50W, but on 20 only, as I
advance the "Carrier" control while transmitting, output rises to about 50W
at 200ma plate current, then falls to 10 watts or so, then plate current
continues to increase (up above the danger level) as the power increases
from 10 to 15W or so. (I only do this for a few secs.) 20 is the only band
the 101E does this on. My finals are near-gone, although I have full output
on 40 and 80, and about 50W on 15 and 10.
>
> Any ideas about which component is acting up? Or is this just likely to be
a side effect of nearly-fried finals? I'm trying to keep the 101E going long
enough to get WAS and DXCC - 5 states and 72 countries to go! Trying for
DXCC on 80 is not going to be much fun :-(
>
> -Wiley KF6IIU
>  Lafayette CA
> Now, more than ever, QSL.NET is in urgent need of your financial support.
>
> Please help QSL.NET by sending a donation now.
>
> ________
> _______________________________________
> Fox_Tango mailing list
> Fox_Tango@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/fox_tango
>