[ForSale-Swap] FS: additional list of parts bundles and miscellaneous items
To Possibilities
topossibilities at verizon.net
Mon Mar 28 11:28:26 EDT 2011
Pretty much everything from last Sunday's list has been spoken for.
Following are some price reductions for a few items that had no inquires and additional component bundles and items surplus to my needs.
Item 1: Large new/unused parts bundle....great way to begin or restock a junk box with commonly used parts and save on shipping/handling, minimum orders etc.
Transistors and FETs....includes many RF and low noise types, (2)2N5179, (1) MFE521, (2) 2N3866, (1) 2N222A, (1) 2N4401, (3) 2N4403, (5)2N4125, (1) MPSH10, (1) MPSA18, (1) MPS6514, (3) 2N3904, (3) 2N3906, (1) 2N5210, (1) MPS918, (1) 2N5088, (1) 2N3053, (2) 2N3819, (2) 2N5484, (2)
2N5386, (2) 2N4416A, (2) MPF102, (1) VN10, (2) J310, (1) BS170
Linear ICs....includes (2) NE5532, (2) NE5534, (2) MC1458, (1) SE510A,(1) LM301, (1) TL074, (1) MC2240P, (2) LM386, (2) LM317L, (2) MC1350P, (1) XR2209CP
Diodes: (4) 1N914, (4) 1N4148, (8) iN4007, (1) 1N34, (1) 2A/400V bridge rectifier, (2) MPN 3404 Pin, (4) 1N6263 Schottky
PCB Trimmer Pots.....(15) assorted values, single and multi-turn
Capacitors.....(25) .1uF 50V Monolithic ceramic
Inductors.....(10) molded type chokes, assorted values from 1uH to 1,000uH
Ferrite materials....nice assortment of (25) toroid, bead, binocular, transformer cores, includes 20' of Belden 24 AWG magnetic wire
Powdered Iron Cores......includes (6) T50-6,(4) T50-6 toroid cores and 10' of Belden 24 AWG magnetic wire
(1) Murata 10.7Mhz ceramic filter
Miscellaneous hardware.......(8) 5/8" x 1/4" screw mount runner feet,(12) 3/16" 4-40 metal stand-offs, (4) 1/2" 4-40 metal stand-offs, (4)1/2" 6-32 metal stand-offs, (4) 1/4" feed though insulators, assortment of 15) single and double solder lugs
Price: $30 Note: I had pre-assembled 12 of these bundles and 2 remain available at this time.
Item 2: Showa SF0922B SSB Crystal Filters, 9.000 MHz Center Frequency, 1 3/8"L x 7/8"W x 13/16"H
Price is $25
Note: Also have 8.9985 MHz and 9.0015 Mhz offset crystals (e.g. 20M and 75M w/ 5MHz VFO) @ $5 each
Note: These are very nice filters (e.g. 2.4KHz BW, 6 pole, flat pass band) but, only had inquiries for the off-set crystals.
Price reduced to $22 and now includes (1) off-set crystal at N/C (3 available w/ 8.9985 MHz, 1 w/ 9.0015 Mhz crystal)
Option: With filter purchase, I can include the PCB and all parts to build the IF amplifier (w/ RF derived AGC) used in the W7ZOI/K5IRK High Performance Communications Receiver receiver that was featured in QST, numerous ARRL Handbooks (e.g. see Fig. 17 Chapter 30, 1995 HB) for an
additional $15.
Item 3: RF power transistors
a) QRP bundle, includes (1) each of NTE346, NTE302, NTE 235 and NTE236
http://www.nteinc.com/specs/300to399/pdf/nte346.pdf
http://www.nteinc.com/specs/300to399/pdf/nte302.pdf
http://www.nteinc.com/specs/200to299/pdf/nte235.pdf
http://www.nteinc.com/specs/200to299/pdf/nte236.pdf
Price: $9
b) Motorola MRF450, NPN, 2-30 MHz, Pout 50W (PEP) Note: used in TenTec 405 amplifier)
http://pdf1.alldatasheet.net/datasheet-pdf/view/116605/MOTOROLA/MRF450.html
Price: $12 each or (2) for $20
c) NTE335, NPN. 2-30 MHz, Pout 80W (PEP), cross to Motorola MRF454. Note: Used in many commercial amplifiers
http://www.nteinc.com/specs/300to399/pdf/nte335_6.pdf
Price: $15 each or (3) for $35
d) NTE333, NPN, 2 - 30 MHz, Pout 60W (PEP)
http://www.nteinc.com/specs/300to399/pdf/nte333_4.pdf
e) Motorola 2N6081, NPN, Pout 15W minimum @ 175Mhz
http://www.digchip.com/datasheets/parts/datasheet/300/2N6081-pdf.php
Price $7
f) MRF479 NPN, TO-220AB (COMMON EMITTER), Po 15W PEP to 50MHz Note: Used in numerous MFJ, popular kits
http://www.datasheetcatalog.org/datasheets2/29/29874_1.pdf
Price: $10
Item 4: Motorola MWA220, .1-600MHz wide band hybrid (3 terminal), 50 ohm 10dB amplifier
http://pdf1.alldatasheet.net/datasheet-pdf/view/120127/MOTOROLA/MWA220.html
Price: $7.50 for a bundle of 3 units
Item 5: Dual gate MOSFet bundle
Includes (9) assorted Motorola 3N211, 3N201, 3N202 and 3N204
Price: $15 several bundles available
Item 6: 3 1/2 Digit Panel Meter Kit (DATAKit 80-340)
Complete kit w/ 7106 processor chip, LCD display, silk screened PCB, all on board components. Instructions include information to make into a mult range volt, current or resistance meter.
Price $10 + shipping
Note: Price reduced to $6
Item 7: Lots of new analog panel meters
These are price reduced meters , many shown on my web site at http://mysite.verizon.net/resota6z/id1.html
a) Very nice Crompton Instruments, 3"w x 2-1/4"h (bottom third black and upper portion clear), expanded scale voltmeter, reads 8-16 volts DC
Price: $10 Note: only 2 available
b) Pair of Hoyt 2-1/2"W x 7/8"H edge type panel meters for measuring/monitoring DC power
Voltmeter is 0-15V and amp meter 0-20 and 0-200 amperes (will need correct shunt).
Price: $8
c) Simpson 3" square panel meter, FS is 0-100uA
Price: $7.50
d) Simpson 2-3/8" square panel meter, FS is 0-500uA
Price: $7.50
e) Weston 1-1/4"W x 3/8" H X 3" D edge type panel meter, FS is 200uA, with bezel and mounting hardware.
New but the internal scale has very slight dis-coloring in one corner.
Price: $5
f) Nice 1-3/4" square panel meter, FS is 50 uA.
Only requires a 1-1/4" round opening to mount (plastic retaining nut fits over threaded body)
Price: $7.50
g) Very nice Vanco Panel Meters, 2 3/8"w x 1 13/16"h .
Model PM-1. 0 - 1mA DC, $8.00
Model PM-2, 0 - 100uA DC, $8.00
Model PM-4, 0 - 15V DC, $8.00
Model PM-5, 0 - 50uA DC, $8.00
Item 8: Air variable capacitors
a) Dual section, 205pF and 75pF with 6:1 vernier drive reduction.
1-5/8"W x 1-1/4"H x 1-11/16"D and has threaded holes for mounting to either panel or chassis.Inner shaft is 1/4" 1:1 where a pointing dial can be mounted. Knob end is 1/8" (1/4" slip on shaft adapter included)
Price: $8 each (2 available)
b) 110pF capacitors with 2:1 gear reduction, 1 1/2" W x 1 1/4" H (plates meshed) x 1 3/4" D, chassis mount w/ 1/2" L 1/4" shaft.
Price: $8 each (2 available)
c) Cardwell ZU-140-A, 140 pF, 1 1/2"W x 1 1/2" H x 1 3/4" D. Has 1/2"L 1/4" shaft. Panel mount in 3/8" hole.
Price $8
d) Hammarlund HFBD35E Dual (split stator) capacitor.
35 pF per section, 2" W x 2" H x 3 1/4" D. Has 2" L 1/4" shaft. Chassis mount.
Price $8
e) EF Johnson 154-1-4 , 244pF, 2,000 volt
http://www.cardwellcondenser.com/PAGES/jcsp17.html
http://www.cardwellcondenser.com/PAGES/jcsc16.html
Same as 154-1-1 except has 1/4" L shaft both ends (can include a 1-1/4"L shaft extension and coupling)
These are the same capacitors that came with the antenna tuner kits (see below site).
Price: $19 each (only 2 available).
The above capacitors are price reduced from shown on my web site at http://mysite.verizon.net/resota6z/id1.html
Item 9: Bundle of air variable trimmer capacitors
a) Johnson subminiature "T" type, silver plated, slot adjust air variable capacitor bundle.
See (CTA) T6-5 at http://www.surplussales.com/Variables/VariableTrimmers/VarTrimm5.html
Includes 18 capacitors, (14) 18pF, (1) 10pF and (3) 5pF
Price: $20
b) Johnson vertical mount, machined silver plated slot adjust air variable capacitor bundle.
See (CTA) 193-8-5 at http://www.surplussales.com/Variables/VariableTrimmers/VarTrimm5.html
Includes (3) 2.2 - 34pF capacitors.
Price: $4.50
Item 10: Silver plated / Teflon center PL259 Bundles
a) Includes (2) PL259s with UG 175/U adapters (RG58?)
Price: $6 5 bundles available
b) Includes (2) PL259s with UG 176/U adapters (RG8, RG59?)
Price $6 4 bundles available
Item: 11 Bundle of miscellaneous connector adapters
Includes an assortment of (14) adapters (e.g. converts between PL259, SO239, BNC, F, right angle, RCA, double male/female etc.)
Price: $12 2 bundles available
Item 12: Bundle of EF Johnson ceramic cone stand-offs and feed troughs
Includes (6) large, (6) medium cone stand-off and (2) medium and (2) medium feed trough insulators
Price: $10
Item 13: Bundle of EF Johnson ceramic 1/4" shaft couplings
a) (6) P/N 104-251-2, large heavy duty couplers
Price $6
b) (8) P/N 104-250 medium size couplers
Price $8
Heat sink bundles and miscellaneous
a) Very nice 5-1/4" x 5-3/4" x 1-1/8" (base 3/8" thick w/ 3/4" fins), charcoal color
Have used these type heat sinks on amplifiers of up to 140 watts output.
Price: $9.00 each (2) available
b) Very nice 4-5/8" x 2-3/8" x 7/8" (thicker base w/ fins), black
Probably good to 50 or more watts output
Price: $6 each (2) available
c) Very nice 3-1/2" x 1-1/2" x 7/8" (thicker base w/ fins), black
Price: $5
d) Very nice 4-3/4" x 3" x 1/2" (w/ fins), black
Price: $4 each (2) available
e) Very nice 4-3/4" x 1-3/4"" x 1/2" (w/ fins), black
Price: $3 each (4) available
f) Very nice 3-1/2" x 2-3/4" x 15/16" (w/ fins), gold anodized
Price: $2 each (4) available
g) Bundle of (15) small, medium and large T05 type heat sinks
Price: $5 (3) bundles available
h) Bundle of (13) small, medium and large T0220 type heat sinks
Price: $5 (3) bundles available
i) Bundle of (16) heavy duty T0220 heat sinks
Price: $7
j) Bundle of (10) T03 type heat sinks
Price: $5
All items are unused/new (NOS) and will be combined and shipped most economical way via USPS (e.g. flat rate box).
Please email w1aaz at verizon.net to verify availability and shipping to your zip.
Ed, W1AAZ
http://mysite.verizon.net/resota6z/index.html
More information about the ForSale-Swap
mailing list