[ForSale-Swap] FS FAA VHF and UHF AM Transceivers

[Byron Tatum]

Hello-
    Have for sale some FAA AM equipment, all solid state:
        Qty 1 of FA8190 UHF AM transceiver - Synthesized thumbwheel selection of 
AM UHF airband freq. This unit was tested and works well, both receive and 
transmit. The receiver has a low noise preamp, selectable helical filters, plus 
a high level passive mixer with strong FET (Crystallonics) follower. Transmitter 
puts out 15 watts. 115 VAC 60 CPS power. Can be remote controlled over tel line. 
Mid to late 70's state of the art. Made by ITT Aerospace. Good cond. Price is 
250.00, item is very heavy (80#) Have manual.

       Qty 1 of FA8191 VHF AM transceiver - Synthesized thumbwheel selection of 
AM VHF airband freq. This unit was tested and works well, both receive and 
transmit. The receiver has selectable helical filters, plus a high level passive 
mixer with strong FET follower (Crystallonics). Transmitter puts out 15 watts. 
115 VAC 60 CPS power. Can be remote controlled over tel line. Mid to late 70's 
state of the art. Made by ITT Aerospace. Good cond.Price is 200.00, item is very 
heavy (80#) Have manual.

    Qty 5 of RT934A/GRC-168 UHF AM transceivers, virtually identical to FA8190 
units, except run off of 115 VAC 60 CPS or 28 VDC. Units were made to slide into 
a special drawer that had power and coaxial mating connections. (No drawers 
available)  Can modify without too much difficulty and install coaxial 
connectors, power connector on rear panel. These were later model units by ITT 
Aerospace, same physical size and layout as others. I have modified and tested a 
couple of these, the others are untested, all good cond. No manual. Sell all 5 
for 500.00

    Have a few GRR-23 and GRR-24 VHF and UHF AM airband receivers, tested. 75.00 
each
                                                Thanks, Byron.