[ForSale-Swap] Sell-Swap Radioshack SSM100 Stereo Sound Mixxing Board

[Danny Dyer]

For Sale or swap, For $100Shipped Cont US, Or Ham Gear,
Radioshack SSM100, Stereo Sound Mixing Board.
you can run up to four mics,/each, in either mono or stereo,
3 stereo CD or tapedecks, and a phono, a total of 8inputs at once.
     **Description And Control Layout.
Turning the board so that the rear of it faces you as the board sits flat on
a table, you have from left to right,
     Bottom row,
power cord,
Philips Head Fuse Holder,
     Next Row Up,
Just Above Fuse Holder,
ground screw with nurled knob,
     Next Are Sets Of RCA Female Jacks,
 1 each for left and right channels,/left being upper, right being lower.
R E C,
AMP,
CD3,
CD2,
CD1,
Phono,
     Then come four quarter inch plugs, with mono-stereo
 left-right little slide switches to the right of each,
Mic4,
Mic3,
Mic2,
Mic1,/the plug to which is broken off and needs to be replaced.
          Then turning the board around, so it's facing you
 in a normal operating position,
going left to right across the top,
 E Q on-bypass,/Bypass being up,Squarish Pushbutton,
     Five sliders with detents in middle,
 <12db at bottom, 0DB at detent, +12DB at top,
60HZ,
250HZ,
1KHZ,
4KHZ,
16KHZ.
   To The Right Of EQ Band Sliders Is V U Meter.
   Directly Below Those Band Sliders Are,
 Two Knobs With Detents in middle,
Left Is Base,
Right Is Treble.

     Below That Section, left to right, 8, Up Down Slider Pots, Labeled,

mic 1,
mic 2,
Mic3/Phono,
Mic4/CD1,
CD2,
CD3,
Master,
Monitor.
   Bottom Row, 2Left-Right Sliders with Detents in middle,
  (These Are CrossFaders, Labeled,)
Mic3Phono,
Mic4CD1,
Eighth Inch Phones Jack.

Above&a little right of Monitor Pot Is
 Squarish Power OnOffPushbutton, up is off.
   Above Sliders3-7 Are Left Right flip switches labeled,
mic3phono out in,
Mic4 CD1 out in,
CD2 out in,
CD3 out in,
Master out in,/with line drawn down to monitor.
     Finally, There are three switches same size and type as preceeding 5,
 Directly Above Switches mic1phono out in,
 mic2 CD1 out in,
 Master out in,
 Which Are Labeled;
Input Device Mic3-phono,
Input Device Mic4-CD1,
Output .775 and 1.5volts respectively:
Thanks, Danny Dyer, Wb4idu,
Email And Paypal,
ddyer1 at gmail.com