[ForSale-Swap] "Carter Collection" BA's FS

[ejones at hiwaay.net]

de N4TGC Eric A. Jones, 6537 County Road 61, Florence AL 35634    256.764.0675

Maybe more like 'debris field', as the mil-surp offerings were ... this
Ham-gear is largely untested.  I will supply detailed descriptions and
pricing on request, as I haven't time to evaluate this stuff at random, in
toto.  Also due to time constraints (mine and yours), I can't respond to
queries rapidly - no 'first $$ gets it' - so no worries if you see this ad
a week later!

Hewlett-Packard 1740A o'scope w/ manual, probes,  padded carry-case, etc.
Dirty but looks complete.  Even if you don't want it, a value estimate
would be appreciated.

Assortment of Tek o'scope probes, such as P6008, 6122, etc.  Some are
damaged; all will be cheap!

Tek 321 3" o'scope.  Vert. input tube (the only one asides the CRT) checks
perfect.  Power and selector switches both replaced/repaired by yours
truly.  Works great on both 117vac and 12vdc (didn't test on 24vdc)
Doesn't quite meet specs - no doubt needs calib.  No manual.  $35

Halli S-85 project receiver - looks generally  okay,  but standby/rec. sw,
phone jack, and spkr are all gone; noise limit and AM/CW sw's loose,
cabinet rusty.  Good for parts or learning on.

S-40A project rig - some rust, pitch control broken, some loose wires
underneath (has been partially re-capped).

S-38B project rig - no back or bottom; getting some rust on front, dial
cord broken, audio xfrmr damaged (typically, the chassis was out of it's
cabinet), two knobs gone.  Likely, I'll have most all the missing/bad parts
here in stock ...

Multi-Elmac AF-67 ser. 3670 - missing the tubes and xfrmrs across the back
shelf, otherwise okay.  Lens decaying.  Includes power jack for rear input.
I'll have the tubes, but not the xfrmrs.

Heath HR-10 and DX-60 pair.  Seem okay overall - missing some tubes and a
knob or two (probably have them).  No manual.  Will test as needed.

Globe Chief Deluxe project transmitter.  Rear bandswitch wafer broken, 2
tubes clumsily added (I'm told it might have been for a modulator), dirty,
one power resistor cracked.

Gonset "Super 6" trio - three v. in various condx, mostly quite good - one
missing shell.

Heath VF-1 VFO - needs some cleaning.  I have partial manual, tube tester,
spectrum analyzer, etc.,  and can test this thoroughly.

HW-202 project rig.  No bottom plate, as-is (I might can test it, but don't
get your hopes up!)

Heath S-2 electronic switch.  Dirty out but clean in, paint peeling some.
Have two.

Heath IB-1 "impedance bridge".  No cabinet, dirty and decrepit, but should
clean up okay.  So rare I had to consult Penson's book!

Heath HW-29A "Sixer" w/ 6425kc xtal and extra cabinet.  Usual minor mods,
pretty good shape overall.  Have mike and manual repro.

Heath V-7A VTVM.  Generally good condx, verified; "C" cell nonsense
eliminated by regulated 1.5vdc internal sply.  Homebrew probe set.  $15, w/
schematic  (I re-furbed this for Ed awhile back)

EICO 315 sig-genny.  Large-format bench rig.  One each early blue-front and
later silver-front.  Both restored and fully checked out and guaranteed.
$35 each, includes manual repro.

Heath SB-10 SSB adapter (have two) - missing meter lens on one, a tube or
two, minor chassis rust, etc.  Can't really test these operationally, but
I'll do what I can ...

Heath HD-1250 transistorized dip meter (have two) - with coils, original
manuals, blow-molded cases.  Can test as needed - not quite 'as new', but
certainly close.

There's this much more again, but I'll save it for the next list - it does
get a little better, I promise!  Query for descriptions and pricing.  If
you make an up-front offer, I just might take it!

de N4TGC Eric A. Jones, 6537 County Road 61, Florence AL 35634    256.764.0675