[ForSale-Swap] microHAM USB Interfaces

[Michael Raskin]

I have two microHAM USB interfaces for ICOM which have been replaced by the 
more expensive USB Interface II:

1) The USB Interface IC was designed for the Icom radios with
   7 PIN DIN ACC(2) jacks

2) The USB interface IC 13 was for use with the IC-706 (and now
   IC-7000) with 13 pin DIN ACC jacks.

The connectors are:

   USB Interface-IC
   For ICOM IC-707, 718, 725/726, 728/729, 735/736 , 737/738,
            746/Pro, 7400, 756/ Pro/Pro2, 761, 765, 775, 78, 781, 820, 821, 
910,
       Ten-TEC Delta II, Argonaut II, Omni VI+, Paragon II
   CAT: 3.5mm phone plug, CW: 6.3mm phone plug, PTT: 7p DIN

   USB Interface-IC13
   For ICOM IC-703, 706, MkII, MkIIG, IC-7000
   CAT: 3.5mm phone plug, CW: 6.3mm phone plug, PTT: 13p DIN

The current USB Interface II drivers (with Router) will work just fine with 
the old interfaces.  Drivers and USB II manual
are available from the download page at the web site.

The old interfaces have a "footswitch" jack (RCA).  That jack is connected 
to the PTT with a diode and the status of the
jack can be read through the CTS line on the virtual port - it is useful for 
allowing the footswitch to interrupt DVK
messages with some software.

You can download the current Router and USB II manual.  The USB II manual 
will provide installation and configuration information
for the driver software (Router) ... the process is identical for both USB 
Interface and USB II.

USB II is a universal interface with internal jumpers to change the type of 
radio interface and adds audio isolation
transformers, but cost $119.

These two USB interfaces are BRAND NEW.  They have never been used.  I 
bought them for my Icom 756 and 706, neither of which I still have.  Comes 
with original one page manual and old software, which can be upgraded for 
free at www.microham.com.

PURCHASE either the microHAM "IC" or microHAM "IC-13"  for $25 each, plus 
shipping.

Mike, W4UM