[ForSale-Swap] TVI filters FS

[Ken Simpson, W8EK]

TVI filters for sale:

Low Pass filters for the transmitter:

Drake TV-5240-LP low pass filter
This number is correct; it is not a TV-5200.  This filter is
different than the typical low pass filter.  It has an SO-239
connector on each end, but instead of being long and skinny,
the enclosure is about 5 inches square.  I think this is a 
fairly old filter.  It has brownish/gray paint over the copper
colored case.  I have not been able to find any specs on
this filter.  It does say "For use in 52 ohm line of transmitters
operating below 30 Mc." printed on it.  $30

Drake TV-1000-LP Low pass filter 
This is the filter that is in the copper case, and may also 
be used on the low end of six meters, as well as HF.  It is 
a 50 ohm filter and is good for 1000 W below 30 MHz, and 
about 200 W up to 52 MHz.  With paper work for $ 30

Drake TV-100-LP low pass filter
This is for lower power -- up to 100 watts.
It has the copper case. It is approaching antique status, 
as I would guess it must be 30 years old, but still works 
fine. Basically it is the same as the TV-1000-LP above, 
but with one tenth of the power ratings.  $ 15

B & W  FL-10/1500 (Also know as model 425)  low pass filter
B & W  TVI filter, 50 ohm. It cuts off just above 10 meters, 
and will handle 1500 Watts. SO-239 connector on each 
end. It is in very nice condition for $ 30.

B & W FL-10/100 low pass filter
Similar to FL-10/1500 above, except power rating is 
only 100 Watts.  Use this one after your rig, and before
your amplifier.  Nice shape for $ 15.

Johnson 250-20 Low Pass Filter
This is a 52 ohm cylindrical low pass filter with a cut 
off frequency of 45 MHz and 75 db of attenuation. 
It is rated to take 1000 Watts of AM, or 5000 Watts 
PEP SSB.  It has SO-239 connectors on each end.
$30.

Kenwood LF-30 A
This is Kenwood's low pass filter, with a cut off of
about 30 MHz, and more than 90 db of attenuation
between 90 and 300 MHz.  It will handle 1000 watts,
and has an SO-239 connector on each end.  It is in
extremely nice condition, with paper work for $35.

High pass filter for the receiver
Drake TV-300-HP
High Pass filter for the TV for 300 ohm twin lead.
This filter is collectable, and is unused as best I can
determine. It is still in its original box (not the newer 
blister pack), with an "RLD" logo on it, and says 
"NEW TV-300 HP High Pass Filter, Attenuates 
0-52 MHz".  Paper work is also with it.  A grounding 
strap is also attached.  $ 15

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone  (352) 732-8400