[ForSale-Swap] Accessories for Kenwood HF xcvrs FS

[Ken Simpson, W8EK]

Accessories for Kenwood TS-120/130 and other 
Kenwood HF transceivers For Sale:

Kenwood VFO-120 remote VFO
This adds split operation to the TS-120 or TS-130 
transceivers.  It is in nice shape, works fine, and 
includes the cable to plug in to the rig, and the paper
work for $95.

Kenwood AT-120 antenna tuner
Matches the TS-120 or TS-130 cosmetically, but could
be used with any HF transceiver in the 100 Watt class.
It has provisions for "straight thru" operation, and includes
a nice lighted meter.  With paper work for $80.

Kenwood MC-50 desk microphone
This is the desk microphone that was used on many
different rigs.  It has both high and low impedance
output, so will match most any rig.  It has a 4 pin
plug wired for Kenwood, but of course that can be
changed. This one works fine and looks fine.  
It includes paper work for $55.

Kenwood MC-35 S hand microphone
This hand microphone is used with most all of the
older Kenwood rigs - TS-120, TS-180, TS-520, TS-820,
etc.  It has a four pin plug on it to match these rigs.
Good shape for $40 

Small Kenwood hand microphone
This is like the small hand mic that came with the
Kenwood TR-7400.  It has the standard 4 pin plug
wired for Kenwood.  It is a 500 ohm dynamic mic.
No model number on it, but it looks close to new, 
and works fine.  If you like a smaller mic, compared
to the MC-35 or MC-30, this is it.  $35 

YK-88 C, CW filter for Kenwood TS-120/130/430/440, and 
many others.
This is a 500 hertz CW filter for the 8.8 MHz IF used in many
of the Kenwood rigs.  Actual center frequency is 8830.7 MHz.
It is the solder in type filter, with steep skirts.  $70

Kenwood YK-88 SN, narrow SSB filter.
Crystal filter for Kenwood TS-120, TS-130, TS-180, 
TS-430, TS-440 and others. 1800 Hz bandwidth. $ 70 

Kenwood SP-230 speaker
This speaker has a switch so that it can be used with two rigs.  
It also has filtering built in to it to help clear QRM, noise, etc.  
It matches the TS-830 and TS-530, as well as other rigs.
This one works 100%, and looks about as close to new as
one can find.  It is in its original box, with paper work for $100.

Kenwood heavy DC power cord
This is the actual Kenwood cord, and not a third party
make over.  It fits all of the Kenwood (and Icom) rigs 
that take the standard 6 pin power plug.  $ 20

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone  (352) 732-8400